Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Garage Door Cost in Tamarac, FL?
Garage door repair in Tamarac typically costs $150 – $600, depending on what failed. A single spring runs $180 – $340, opener repair is $120 – $320, and a brand-new door installed lands between $700 – $2,200. Those are typical estimated ranges for this market; the written estimate sets the final price.
That spread is wide on purpose. A snapped cable and a dead opener motor are both “a broken garage door” to a homeowner, but they’re different jobs with different parts behind them. The table below breaks out what each job usually runs in Tamarac so you can match your problem to a number before you call.
- Fast dispatch, 7am-7pm, Sunday through Friday for the estimate
- Free estimates, and the written estimate sets the price per job
- We work on LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment
- Our technicians have up to 11 years of experience
Garage Door Cost Breakdown (2026)
Here’s how the work breaks down in Tamarac. Every line is a typical estimated range, and the written estimate you get on site is what you pay.
| Service | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $180 – $340 |
| Cable repair | $130 – $250 |
| Opener repair | $120 – $320 |
| Opener installation (new unit) | $250 – $550 |
| Panel replacement | $250 – $500 |
| Track realignment | $120 – $240 |
| Roller replacement | $110 – $220 |
| New door installation | $700 – $2,200 |
| General garage door repair | $150 – $600 |
One thing worth knowing before you compare quotes: a spring price covers one spring. Most doors run two springs, and they’re almost always replaced as a matched pair so the door lifts evenly. A pair costs about twice the single-spring range. If a company hands you a single-spring number on a two-spring door, ask what that quote actually covers.
What pushes a job toward the top of its range? Rusted or snapped cables on an older door, a bent track from a car bump, or an opener whose logic board is done rather than its gear. What keeps it at the bottom? A single worn roller, a door off its track by an inch or two, or an opener that just needs its travel limit reset. New door installs swing wide because the door size and material drive the price: a single-car steel door sits low in that range, a double door or a heavier insulated model sits high.
If you’re not sure which line you’re in, Sunrise Garage Door Repair Co can tell you once we’ve seen the door.
What Affects Garage Door Pricing in Tamarac
- Door size and material. A single-car door and a two-car door don’t share a price, and a steel panel door costs less than an insulated or wood-look model. This is the biggest lever on installation pricing.
- One spring or a matched pair. Explained above, but it comes up often enough to repeat: two-spring doors get two springs, and the pair is priced accordingly.
- What actually failed. A dead opener can be a $15 part or a logic board. We won’t know which until the door’s been looked at, and quotes given blind tend to change once the truck arrives.
- Age of the door and opener. Tamarac’s heat and humidity work on steel and on opener electronics over the years. Older equipment often needs more than one part at a time, and a technician who’s been in the trade a while can spot the next failure before it strands you.
- Brand and parts availability. This is why we service all eight of the common residential brands rather than one. If your door carries a LiftMaster or Chamberlain opener, or the panels are Clopay or Amarr, the parts are findable and the job doesn’t stall waiting on a special order.
- Emergency timing. A door stuck open is a security problem, and we treat it that way. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday. The price itself is still set per job by the written estimate.
Why Tamarac Doors Fail the Way They Do
South Florida’s humidity is the quiet factor in a lot of the repair calls we get here. Steel panels take on moisture, hinges stiffen, and rollers that ran smooth in a drier climate start to drag. A dragging door puts extra load on the opener and the springs, which is how a small maintenance item turns into a bigger repair. The other local reality is storm prep: homeowners here cycle their doors more than people in milder climates, checking them before a system rolls through, and that wear adds up.
Most of Tamarac’s housing is block construction with attached garages, and a lot of the neighborhoods were built out in waves. That means you’ll see several vintages of door and opener on the same street, from original equipment to a recent replacement. If your neighbor’s door is quieter than yours, it’s probably newer, not better maintained.
The Safety Part We Won’t Skip
Springs and cables are under serious tension. A torsion spring can injure someone badly if it’s released wrong, and we don’t give step-by-step instructions for that reason. Same for anything involving the opener’s wiring or the panel. We’d rather you leave it and call.
Cables are the other one. A frayed cable can whip when it lets go, and it usually lets go while someone is standing under the door. If you see strands broken or the door hanging uneven, stop using the opener and garage door repair is the call.
How to Save on Garage Door Costs in Tamarac
The most reliable way to keep a garage door bill down is to catch problems early. A door that’s started to squeak or lift unevenly is usually a cheap fix; the same door six months later is a spring, a cable, and an opener. Here’s what actually helps:
- Get the estimate before the work, in writing. Free estimates mean you can compare real numbers instead of guesses. Call (877) 685-2138 and we’ll set one up.
- Fix the small thing now. Roller replacement at $110 – $220 beats a spring job at $180 – $340 plus a cable repair. Worn rollers drag the whole system.
- Replace springs as a pair. It costs more up front than one spring, but a mismatched pair puts uneven load on the door and usually means you’re back in the same spot sooner.
- Repair the opener before replacing it. Opener repair at $120 – $320 is often the right move. A full replacement at $250 – $550 makes sense when the unit is old and the board is gone, not when a gear stripped.
- Match the door to the house, not the brochure. On a new install, the $700 – $2,200 range covers a lot. A well-chosen steel door in the lower half of that range will outlast a fancy one that’s undersized for the opening.
- Don’t let a small misalignment ride. Track realignment at $120 – $240 is a quick job. Ignored, a bent track chews through rollers and can crack a panel.
We handle springs, openers, panels, and installs under one company, so you’re not sourcing three contractors for one door. That saves you the coordination time even when the parts cost is what it is.
Repair or Replace? The Honest Math
If the repair comes in under about a third of what a new door would cost, repair is usually the better call. Once you’re looking at a full panel set, a bent track, and a failing opener on the same door, the numbers start pointing the other way. A door that’s been patched repeatedly tends to keep asking for money. We’ll tell you which side of that line your door is on rather than pushing a replacement you don’t need.
FAQs – Garage Door Costs in Tamarac
How much does garage door repair cost in Tamarac?
Garage door repair in Tamarac typically costs $150 – $600, with most single-issue jobs landing in the lower half. The written estimate sets the final price. Call (877) 685-2138 for an exact quote on your door; estimates are free.
How much does a new garage door cost installed in Tamarac?
A new door installed in Tamarac typically runs $700 – $2,200. The range depends mostly on door size and material. A single-car steel door sits near the bottom; a double or insulated door sits near the top. Call (877) 685-2138 for a written estimate.
Is it cheaper to repair or replace a garage door?
Repair is usually cheaper when the fix costs under roughly a third of a new door. Past that, replacement often makes more sense, especially if the door has needed repeated repairs. A free estimate will give you both numbers side by side. Call (877) 685-2138.
How much does spring repair cost in Tamarac?
Spring repair in Tamarac typically costs $180 – $340 for one spring. Most doors have two springs and they’re replaced as a matched pair, so a pair costs about twice that range. Call (877) 685-2138 for an exact quote; estimates are free.
Can you come today if my door won’t close?
Yes, same-day service is available, and a door that won’t close gets priority because your home is open. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday. Call (877) 685-2138 and we’ll book you in.
Do you work on my brand of door or opener?
We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment. If that’s what’s on your house, we’re the call. Call (877) 685-2138 to confirm your model and get an estimate.
Get Your Free Tamarac Garage Door Estimate
Pricing on this page is a starting point, not a quote. The door has to be seen to be priced right, and that’s what the free estimate is for. Call (877) 685-2138. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Whether it’s a spring, an opener, a panel, or a whole new door, you’ll get a written number before any work starts.
Pricing reflects the Tamarac market as of 2026. Sunrise Garage Door Repair Co offers free estimates – call (877) 685-2138.
What Our Customers Say
"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Daniela Torres"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Stephanie Brooks"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- Tara Bennett